Skip to main content

Sound comparison: standard drywall, QuietRock, Green Glue

The Knock Test


REPOSTED FROM MY PREVIOUS BLOG:

By knocking on a wall,  you get some idea of how well dampened it might be for certain types of noise...or not.

I made a very short video demonstration in my own home to compare the audible differences between making an impact noise on normal, uninsulated gypsum drywall and two alternatives. The first example shows how it sounds to knock on a hollow piece of 1/2" gypsum board. This type of drywall is typical for mid-century American homes. 

Then compare it to:

1) a second layer of sheetrock glued on top of the original drywall with Green Glue in between the two layers -- no demolition required.

2) a layer of QuietRock 525 that replaced the existing layer of gypsum -- demolition required. Original 1/2" drywall was removed and fiberglass insulation was added before screwing the new QuietRock into the wall studs. One layer only. 
(NOTE from 2023: Now I know better, and I would have decoupled the drywall from the wall studs instead of screwing it in!)

Notice how "dead" the Green Glue wall and the QuietRock sound, compared to the original drywall!

Labels:

Comments

  1. Ryan W.December 23, 2010 at 6:47 AM

    looks like the volume of the sound is roughly proportionate to how hard you knock. : )

    ReplyDelete

Post a Comment

Popular posts from this blog

Two layers of drywall and Green Glue

Another YouTube video: layering drywall I have to admit: I never get tired of seeing other people's soundproofing videos. Here's a video from Acoustical Surfaces that shows two guys building a wall out of 2x4s and insulating them with cotton batts, and then layering two sheets of drywall over each side. They make sure not to overlap the seams between the two layers, and they use two tubes of Green Glue on each 4x8 sheet of drywall. We don't get to hear the results, but if I were them, I might have either staggered the wall studs (since they were building the wall from scratch), or put soundproofing green tape (aka " joist tape ") on every other stud to keep the first layer of drywall from touching the wood (a "fake" staggered wall).
Post a Comment
Read more

Combining QuietRock and Green Glue together

Two great products work great together. As I've mentioned before, I'm experimenting around with ways to reduce some of the noise problems in my apartment on a tight budget. I think I've found the best combination to date: adding a layer of QuietRock 510 over an existing layer of gypsum drywall with a layer of Green Glue inbetween. This was sort of the best of both worlds: taking a pre-made, sound-dampened drywall and then adding it over a powerful, viscous layer of glue....onto drywall that was already on the wall studs. No demo needed. In this project, I basically added two sound-dampening layers to the original 1950s drywall (one layer in the QuietRock and the other layer created by the Green Glue) to address " flanking noise ": feet, furniture, and shoes pounding on the bare floor of my downstairs neighbors' apartment. The amount of banging, bashing, and foot-stomping sounds coming from their very "wooden" apartment has been severe, and I...
10 comments
Read more

How to measure decibels with the NIOSH sound level meter app

For a quick lesson on how to use the NIOSH (National Institute of Occupational Safety and Health) app to measure decibels and noise, check out my latest Soundproofist  video. This handy app is free, although only available for iOS devices right now. It's a great app to use if you want to measure average and maximum noise levels with either A-weighted or C-weighted decibels. You can save each measurement as a report. Learn more about measuring noise and about soundproofing from  Soundproofist . Download the free NIOSH app from the App Store and learn more about it from this CDC documentation .
Post a Comment
Read more